IP Phone Endpoints¶
QVOICE Platform IP Phone Endpoints¶
Supported Endpoints
- Polycom
- Yealink
- Fanviel
- Cisco
- HTEK
HTEK Endpoint Provisioning¶
Registering Phone¶
This chapter describes how to register a Htek phone using TFTP.
HTEK TFTP Configuration¶

2. Login to phone web administration interface
If there is no DHCP in your network, you can still auto provision your Htek phone. Please refer to your HTek phone model User Guide for instructions about setting a static IP address. After you configure your HTek phone to use a static IP address, continue with the following steps.
- Open a new browser window and enter your phone's IP address to access the phone's web administration interface login screen. For example: http://192.168.1.2
- Login to the phone's web administration interface with your username and password. Please note the factory default login details are username: admin and password: admin.
- Click on the Management tab.
- Click on the Auto Provision tab.
- You can use TFTP protocol in order to Auto Provision your Htek phone.
- For the Upgrade Mode, Choose TFTP.
- In the Config Server Path field, enter Hostname or IP Address.
- Set hostname TFTP UFL: tftp://{system_url}:60069/provisioning/htek
- Make sure you replace the Hostname or IP Address from this example with your QVOICE Platform Hostname or IP address.
- Click on the Save Set button at the bottom of the page.
You will have to wait for the device to save the changes.
- Click on the Auto Provision button to run the auto provisioning process.
- The auto provisioning process will start during the phone reboot process. The phone will pick up the appropriate configuration file from QVOICE Platform. If everything is done as above described, you should have successfully registered your phone to QVOICE Platform. Dial *98 (Voicemail) to verify registration.